A roll of pre-punched fixing band for hanging and bracing pipework, ducting and sheet metal. The slots are already there, so you cut a length, wrap it and screw it off - no drilling and no measuring out hole centres.
Key features
Pre-punched slots along the full length, so fixings go anywhere you need them
Bends by hand to wrap a pipe, a duct or a bracket
Supplied as a roll, so you cut only what the job takes
For plumbing, heating, ducting and general sheet metal work
Cuts with tin snips
Form: roll, cut to length
Finish: galvanised
Pre-punched multi-slot band
For pipe support, duct hanging and sheet metal work
How to use it
Cut the length you need with tin snips and file the cut end if it is sharp. Wrap it round the pipe or duct, line up a slot with your fixing point, and screw it off. For a heavy run, use two bands rather than overtightening one.
